JBH micro thermostat

JBH micro thermostat

In addition to displaying the temperature and temperature regulation, the JBH micro thermostat is able to control the temperature in both cooling and heating operating modes based on the user’s adjustable temperature.

Technical specifications of JBH micro thermostat

Flow measurement range: +110 + 50 ° C

Resolution: 0.1 ° C for the range (99.9 ۹ + 9.9) and 1 ° for the outside range

Measurement accuracy: 0.1 ° C

Control accuracy: 0.1 ° C

Reading cycle: 0.5 seconds

Power supply: 12 VDC 200 mA

Measuring sensor: NTC 10 K waterproof

Output relay current: 10 amps

Operating temperature of the device: +60… -10 degrees Celsius

Working humidity: 85% ۲۰ 20%

Dimensions of the front frame: length 48 mm, width 29 mm, depth 32 mm

Rear frame size: length 46 mm, width 26.5 mm

How to apply the settings

e segments, flashes. Then the value of this parameter can be increased and decreased with both buttons. Use the ‘C /’ F button to switch between Celsius and Fahrenheit. This thermostat has 9 functions P0 to P9. Hold down the SET key for a few seconds until P0 appears. Release the key and then move between functions each time you press the SET key. To set each of these 9 functions, hold down both buttons simultaneously until the numeric value of the corresponding parameter flashes. Then increase and decrease the numeric value of the parameter with the up and down buttons.

Introduction of functions

P0: C (cooling) H (heating)

P1: Adjusts the hysteresis temperature value

P2: Limit the set point by setting the maximum set point

P3: Limit the set point by setting the minimum set point

P4: Calibrate the current temperature

P5: Set the delay time in connecting the relay if the current set point and temperature are equal

P6: Enable or disable P2 and P3 functions

P7: Change the unit of measurement from Celsius to Fahrenheit and vice versa

P8: Enable or disable factory settings